On this page
Leak detection in Fort Worth: the short version
Fort Worth is in Tarrant County. Our Dallas–Fort Worth team covers it. Leak detection in Fort Worth is $550 for a pool or a spa and $650 for both, the same price we charge across Dallas–Fort Worth. That covers every line pressure tested, a dive and dye test of the shell, simple leak stops included when it makes sense, and a photo and video report where available. You get the repair price before any work starts, and same-day service when possible.
Fort Worth pools range from older homes in Westover Hills, Rivercrest and Tanglewood to newer builds on the edges of town. The ground changes too, from clay over limestone in town to sandier soil to the north and east.
Clay over limestone in Fort Worth
Much of Fort Worth has a thin layer of clay over limestone and chalk. Pools here are often cut partly into rock, and the lines run through trenches in the rock or in the clay above it. Rock barely moves. The clay on top of it moves a lot. Where a line passes from one to the other, the fitting takes the strain, and that is a common place for a crack.
Water from a leak can also travel a long way along the top of the rock before it shows, so a wet spot in the yard is not always over the leak. And where the soil is thin, some lines sit shallow, which matters when a hard freeze comes through.

After a hard freeze, check the equipment pad and any exposed pipe for cracks before you run the pump on high.
Leak or evaporation in Fort Worth?
On a hot, windy July day a Fort Worth pool can lose about a quarter inch to evaporation, a bit more when the air is dry. If your pool drops more than that, or keeps dropping when the weather cools, it is worth a closer look.
The easiest check is a bucket test: a bucket of pool water on the pool step, marked inside and out, for 24 hours with the auto-fill off. If the pool drops more than the bucket, the difference is water leaving through a leak. Our leak checker compares your numbers with the weather where you are.
Where we find leaks in Fort Worth pools
- Lines where rock meets clay. Fittings crack where the ground on one side moves and the other side does not. More on this.
- Shallow lines after a freeze. Thin soil gives less protection in a hard freeze. More on this.
- The skimmer. The most common leak spot in any pool. More on this.
- The main drain. A leak at the bottom of the pool, often found with dye. More on this.
- The equipment pad. Freeze cracks in pumps, filters and valves. More on this.
Every pool is different, so we test the whole system instead of guessing: how a leak detection works.
Neighborhoods and nearby cities we cover
In and around Fort Worth we cover every neighborhood, including Westover Hills, Rivercrest, Tanglewood and Mira Vista.
Close by, we also cover:
- Pool leak detection in Haltom City
- Pool leak detection in Saginaw
- Pool leak detection in North Richland Hills
- Pool leak detection in Benbrook
- Pool leak detection in Hurst
- Pool leak detection in Crowley
Homeowners, home buyers and realtors, pool service companies, HOAs, apartments and hotels all book with us. See commercial pools or every area we cover.
Booking a leak detection in Fort Worth
Book online in about a minute, or text us your address. Before we come, keep the water clear with no algae, the pool at its normal level and the pump running a few hours. You do not need to be home: we send the report either way. Financing is available on everything we do, including the repair estimate, subject to approval.
Questions
How much does pool leak detection cost in Fort Worth?
$550 for a pool or a spa and $650 for both. Fountains and water slides are included; other water features and extra pumps are $99 each. Every line is pressure tested, and you get a photo and video report where available and the repair price before any work.
How soon can you come to Fort Worth?
Same-day service when possible. Our Dallas–Fort Worth team covers Fort Worth; book online or text your address and we confirm the day and time by text and by email.
Can a hard freeze crack my pool lines in Fort Worth?
It can. Much of Fort Worth has thin soil over rock, so some lines sit shallow, and pipes and equipment above ground are exposed. Keep the pump running in a freeze, and if the water drops after one, have the lines and the equipment pad pressure tested.
Do you work on HOA, apartment and hotel pools in Fort Worth?
Yes. We test community pools, apartment and hotel pools, rooftop pools and city pools, with the same flat price up to 30,000 gallons and a custom quote for bigger pools.



